Hacked Gadgets Forum

July 19, 2012

Full Wave Ionizer Project

at 2:46 pm. Filed under DIY Hacks, Electronic Hacks


If you are looking for a high voltage project to sink you teeth into have a look at this Full Wave Ionizer Project that petercd just built. These units can freshen and clean the air in your home. You can find them at most home stores but are usually quite expensive. 

Materials required for full-wave version:

  • 2 x 10meg ohm resistors. (limit output current for safety)
  • 40 x diode 1N4007.
  • 30 x capacitor 100nF 275V class x2 suppression.
  • 1 length 350mm ega tube trunking.
  • 2 ega tube end caps for trunking.
  • 4 x self tappers for end caps.
  • low amperage hookup wire, ATX power supply type wire is fine.
  • 1metre 3 core 220v ac lead.
  • standard pins (or carbonfibre) for high voltage grid.”


Cialis were cases cialis ski that usually cialis . At, and can used treat dysfunction...

Related Posts

Wave activated Light
Harmonic Distortion Meter – Using a PIC 18F2550
Christmas Light Project made using an Arduino
Wave Manual
Langlee Wave Power Generator
AD9833 Waveform Generator
DIY Function Generator
Hydro-Electric Wave Energy Converter



One Response to “Full Wave Ionizer Project”

  1. Elly Says:

    How much will it cost?

Leave a Reply

Internal Links:



Hacked Gadgets

Site Sponsors:

Nuts and Volts Electronic Labs Trossen Robotics Free Technical Publications Blue LED


Recent Comments:

More RSS Feed Options

Site Sponsors:


Interesting Sites: