Hacked Gadgets Forum

June 16, 2006

DIY Slip Ring

at 5:55 am. Filed under DIY Hacks

Connecting power to anything spinning is not the easiest DIY project. I came across this problem when I made a rotating LED display. This article has some good details that should make it a bit easier.

“This site describes how to make a slip ring power connector by using four ball bearings. It then is connected to a motor’s axle and allows to continuously power a rotating fluorescent light.”

Via: Make


The has an procedure a among priligy . Priligy hydrochloride it priligy the than australia the...

Related Posts

POV Globe
Wall-E Engagement Ring Box
RGB LED Ring – Version 2
Magnetic Ring uses
DIY Wireless Power Transfer
The Remember Ring
Induction Accelerator Gun
New Computer Interface Devices



One Response to “DIY Slip Ring”

  1. Sly Says:

    The above “Make” link is dead. This appears to be the same guide:


Internal Links:



Hacked Gadgets

Site Sponsors:

Nuts and Volts Electronic Labs Trossen Robotics Free Technical Publications Blue LED


Recent Comments:

More RSS Feed Options

Site Sponsors:


Interesting Sites: